[pilot80]

اخواني اقدم لكم أخر أصادر من الايربص ايروسوفت وفيه كثير من التعديلات المهمة جدا
MCDU (left)

• Added: It is now possible to save and reuse company route flight plans to which single waypoints manually have been added. If you want manually to add a waypoint just enter it into the scratchpad and then press the respective LSK L before which existing waypoint this new one should be added.
• Changed: DME Arcs Entry and Exit significantly reworked.
• Changed: TP now curved, will form a curved line to the Great Circle Line.
• Changed: Track from a fix for a Distance and Track from a fix to a DME Distance legs completely reworked.
• Fixed: All PBD issues.
• Fixed: DIR TO issue resulting in flashing line.
• Fixed: LNAV lost when going to NAT waypoint issue.
• Fixed: Navdata reading issue associated with Navigraph.
• Fixed: INCPT does not keep moving around now.

PFD

• Added: Added V1 and V2 Indications.
• Added: ALT Armed Magneta added for CSTRs.
• Added: Metric Alt added
• Added: Several new FMA added related to VDEV for Non-ILS Approaches.
• Changed: GS now always remain active once GS is captured once.
• Changed: VDEV(or also known as green dot) added, RNAV still not fully supported yet though.
• Fixed: Alt numbers on alt tape now turns orange when passing through MDA/DH
• Fixed: CAT X / DUAL / SINGLE Word removed when non-ILS Approach
• Fixed: GS* Active and GS Armed at the same time Fixed.
• Fixed: MDA now does not auto degrade to CAT1 with AP ON.
• Fixed: STD/QNH flashing reworked to FCOM.
• Fixed: VSI negative indication removed.
• Fixed: When on ground, FD bars dont appear till thrust levers at or above CL.

ND

• Added: DECEL point added on ND
• Fixed: ND items flickering when operating very close to the equator fixed.
• Fixed: ND items behind datum line (IDL) were not displayed correct until passing that longitude

FDE

• Changed: Major revision to Lift/Drag Model, more accurate climb/descends, acceleration/deceleration.
• Changed: New Flaps model, revised lift/drag.

Checklist- / Copilot Functionality

• Fixed: After Start CL / THS setting; there were problems with the trim position if the distance to the set point was too big.
• Fixed: MDA; The Descent Preparation CL did not recognize if MDA was used (MCDU PERF APPR page) instead of DH. Now solved i. e. also MDA is recognized.
• Fixed: User States Doors; if a user state has been saved the situation of the left passenger doors as well as of all right cargo doors were not saved. Now those states are also saved.
• Changed: FINAL Checklist; The Final CL activation now is independent from the activation of the MCDU PERF APPR mode activation. The FINAL checklist will be automatically started under the following conditions: Distance to runway > 30 NM Flight path is > 90 degrees compared to the runway course
• Changed: Deceleration Pseudo- waypoint Automatic activation of APPR mode
• APPR phase is automatically activated at the DECEL pseudo waypoint provided that NAV mode is engaged and altitude is below 7.200 feet AGL. The (DECEL) pseudo waypoint is calculated by the FMGC to initiate deceleration in order to be stabilized at VAPP at a specified point on the approach profile, normally at 1000 feet AGL.
• The Deceleration point is now displayed on the ND (magenta circle). The APPR mode should have been activated before reaching this point. Passing the DECEL pseudo waypoint the APPR mode automatically will be activated.
• Changed: Landing Memo; The conditions for the Landing Memo are: > 2000 feet RA above runway altitude & Flight mode: Cruise or Approach
• Changed: High Altitude Airports; There are high altitude airports like Quito / Ecuador at an altitude of app. 9.000 feet. Using the Copilot functionality caused problems during CLIMB as well as DESCENT. Therefore for such airports (< 5.000 feet) the functionality has been changed as follows: During the CLIMB CL the 10.000 feet call is omitted and the landing lights are switched off by the copilot after the Baro Check at the transition level. During the DESCENT also already at the transition level (< 10.000 feet) the Landing Lights as well as Landing System are set to ON by the copilot.
• Changed: TCAS; The checklist and copilot functionality now will be changed so TILT in the "AFTER TO CL" will stay on ABV but the checklist now also accepts ALL. In the CRUISE CL if necessary the copilot then sets the TILT to ALL (if not previously done by the user).
• Added: Baro Checks during Descent Checklist; The Landing Elevation Check as part of the Descent Preparation Checklist has been disabled i. e. it is not mandatory anymore to fill the QNH-field in the MCDU PERF APPR page. But if a value is entered the unit used (inHg or hPa) must be identical with the settings the FCU QNH display. If the unit is later Changedd the value in MCDU PERF APPR page automatically will be adjusted.
• The following situations have been checked and are normally used during the DESCENT and APPROACH checklist:
• 1. Copilot ON MCDU PERF APPR page: QNH value available = Copilot enters this value into the FCU QNH-display
• 2. Copilot ON MCDU PERF APPR page: QNH value not available = Copilot uses the ambient pressure value like pressing [B]on the keyboard and enters this value into the FCU QNH-display
• 3. Copilot OFF MCDU PERF APPR page: QNH value available = User himself enters manually the QNH-value into the FCU QNH display
• 4. Copilot OFF MCDU PERF APPR page: QNH value not available = User himself enters manually the value of the destination airport into the FCU QNH display
• 5. Copilot OFF MCDU PERF APPR page: QNH value not available = User himself uses [B] from the keyboard to automatically enter the ambient pressure value.
• Changed: ACFT STATE TAXI - Selected Altitude; If the user forgets to enter a first altitude the copilot (if used) automatically enters during TAXI an altitude of 7.000 feet.
• Changed: ACFT STATE TAKEOFF Selected Altitude; When loading the TAKE OFF aircraft state the FCU altitude was set to 100 feet. Now the minimum selected altitude is already set to 28.000 feet.
• Fixed: CHECKLIST INFOBAR; If the user started Engine 2 before getting the permission by the Ground Crew, the information on the infobar START ENGINE 2 remained.
• Changed: BEFORE TAKEOFF CHECKLIST; The checklist started automatically when the runway holding point was passed. If the copilot was not used this sometimes caused stress and got problems because during immediate takeoff the checklist was still running and collided with the TAKEOFF checklist. Therefore the plane now has to be fully stopped after passing the runway holding point to automatically start the checklist. Manually it still can be started at any point using [1] from the keyboard.
• Added: TAKEOFF with FLAPS 3; The copilot functionality has been adopted so that takeoff with flaps 3 now is also possible.
• Changed: TURNAROUND; There have been problems with the automatic TURNAROUND aircraft state after the PARKING CL had been finished i.e. flaps and groundspoilers ARM did not work as required. Problem should be solved now.
• Changed: Cockpit Preparation CL after Turnaround; The cockpit preparation CL after Turnaround has been modified i. e. certain procedure checks will be omitted like Batteries, External Power and Navigation Lights etc. More details in the Vol6 StepbyStep Guide.
• Fixed: ECAM STATUS CHECK; If the CLR button is ON it is necessary previously to confirm a warning message.

MCDU (right)

• Changed: DEFAULT AIRCRAFT STATES; The default aircraft state CRUISE has been deleted (due to problems with the AP status and data) and instead a new default state TURNAROUND has been added. This state is the same than the settings after the PARKING checklist has been finished and the plane is set back for a new turn.
• Changed: USER STATES (SAVE and LOAD); There had been problems with saved / loaded user states and the status of the MCDU (left). Some MCDU fields were not automatically filled respectively looked and behaved different compared to the MCDU after using a standard ACFT STATE like p. e. DARK & COLD. Those problems now have been solved.
• Changed: SOUND OPTIONS; The sound volume in the cockpit can now be set to LOW or NORMAL. LOW means that the sound for Batteries, Cooling and Avionics are reduced by 15%.

Fuel Planner

• Added: Balance has been added (relation between Trim and Center of Gravity).
• Changed: Fuel loaded now changes according to weight of aircraft.
• Changed: New layout
  
• هذا هو الرابط مجرب و مضمون ان شاء الله
• https://thepiratebay.sx/torrent/84533...A320_321_V1.10
• هذا رابط الاصوات الجديدة
• https://thepiratebay.sx/torrent/84585..._E._2013_V1.10

[uaemaster]

الف شكر كابتن على التحديث المهم لا تحرمنا من جديدك

[pilot80]

اقتباس:     المشاركة الأصلية كتبت بواسطة uaemaster  

الف شكر كابتن على التحديث المهم لا تحرمنا من جديدك

اهلا وسهلا اخي

[pilot80]

شباب هل من الممكن 296 مشاهدة من دون تعليق؟

[Captain-rakan]

الف شكر كابتن على التحديث وماقصرت
ربي يعطيك العافيه
ولا تحرمناا من جديدك :)

[amjad22]

اشكرك اخي الكريم على هذه الطائرة الرائعه
ولكن
اواجه مشكله اثناء الرحلة بعدم ثبات الطائرة

يا ريت تساعدوني بحل المشكله

في انتظار الرد

[pilot80]

اقتباس:     المشاركة الأصلية كتبت بواسطة amjad22  

اشكرك اخي الكريم على هذه الطائرة الرائعه

ولكن
اواجه مشكله اثناء الرحلة بعدم ثبات الطائرة

يا ريت تساعدوني بحل المشكله

في انتظار الرد

السلام عليكم اخي قصدك انه الطائرة بتهز كتير ولا كيف"؟ تحياتي

[وقت الرحيل]

اقتباس:     المشاركة الأصلية كتبت بواسطة pilot80  

السلام عليكم اخي قصدك انه الطائرة بتهز كتير ولا كيف"؟ تحياتي

اعاني من نفس المشكله

[محمد شوبكشي]

كبتن يعطيك العافيه على المجهود الرائع بس ممكن تشرح طريقه تحميل الطائره من الموقع

[abdullah f]

يعطيك العافية

[smartboy]

ما قصرت يعطيك العافية

[sherifgd]

ألف شكر على الطائره الرائعه و الإضافات المهمه
تسلم الأيادى على هذه المشاركه القيمه

[مقلع بدون هبوط]

الف شكر علما باني متابع لكن ما اعرف انجليزي
لكن جهد تشكر عليه


iPhone بإستخدام Tapatalk

[pilot7]

الوصلة لاتعمل